Tweco 2460 Heavy Duty CC CV Control Wire Feeder - Manual (Page 37)

PARTS LIST FOR ASSEMBLY NUMBERS 376799A-1,-2, -3, -4
Equipment Identification
All identification numbers as described in the In-
troduction chapter must be furnished when ordering
parts or making inquiries. This information is usually
found on the nameplate attached to the equipment.
Be sure to include any dash numbers following the
Specification or Assembly numbers.
How To Use This Parts List
The Parts List is a combination of an illustration
(Figure Number) and a corresponding list of parts
which contains a breakdown of the equipment into
assemblies, subassemblies, and detail parts. All
parts of the equipment are listed except for commer-
cially available hardware, bulk items such as wire,
cable, sleeving, tubing, etc., and permanently at-
tached items which are soldered, riveted, or welded
to another part. The part descriptions may be in-
dented to show part relationships.
To determine the part number, description, quan-
tity, or application of an item, simply locate the item
in question from the illustration and refer to that item
number in the corresponding Parts List.
An “Application Code” is used to distinguish parts
that are applicable only to certain Specifications
and/or Assemblies. This code is found in the right-
most column of the Parts List. If an item in the Parts
List applies to all Specifications or Assemblies, the
word “ALL” will be in the Application Code column.
Refer to the following list to determine the appropri-
ate Application Codes for the Specifications or As-
semblies covered by this manual. If only the
assembly or specification number is listed, the use
of an Application Code does not apply to this man-
ual.
ASSEMBLY NUMBER APPLICATION CODE
376799A-1 A
376799A-2 B
376799A-3 C
376799A-4 D
MPL-224
PARTS LIST FOR ASSEMBLY NUMBER 376799A-1, -2, -3, -4
May 29, 1996 Revised Page 1