Tweco 200DC Inverter Arc Welding Machine - Manual (Page 19)

WELDSKILL 200AC/DC INVERTER
Manual 0-5207 3-1 INSTALLATION, OPERATION AND SETUP
SECTION 3:
INSTALLATION, OPERATION AND SETUP
conditions. For further information please refer
to AS 60529.
H. Precautions must be taken against the power
source toppling over. The power source must
be located on a suitable horizontal surface in the
upright position when in use.
3.03 Ventilation
Since the inhalation of welding fumes can be harmful,
ensure that the welding area is effectively ventilated.
3.04 Mains Supply Voltage
Requirements
The Mains supply voltage should be within ± 15%
of the rated mains supply voltage. Too low a voltage
may cause poor welding performance. Too high a
supply voltage will cause components to overheat
and possibly fail.
The Welding Power Source must be:
• Correctly installed, if necessary, by a qualified
electrician.
• Correctly earthed (electrically) in accordance
with local regulations.
• Connected to the correct size power point and
fuse as per the Specifications on page 2-5.
!
WARNING
Any electrical work must be carried out by
a qualified Electrical Tradesperson.
3.05 High Frequency Introduction
The importance of correct installation of high frequency
welding equipment cannot be overemphasized.
Interference due to high frequency initiated or
stabilised arc is almost invariably traced to improper
installation. The following information is intended
as a guide for personnel installing high frequency
welding machines.
!
WARNING EXPLOSIVES
The high frequency section of this machine
has an output similar to a radio transmitter.
The machine should NOT be used in the
vicinity of blasting operations due to the
danger of premature firing
3.01 Environment
These units are designed for use in environments
with increased hazard of electric shock as outlined in
AS60974.1 and AS1674.2
A. Examples of environments with increased hazard
of electric shock are:
1. In locations in which freedom of movement
is restricted, so that the operator is forced
to perform the work in a cramped (kneeling,
sitting or lying) position with physical contact
with conductive parts.
2. In locations which are fully or partially limited
by conductive elements, and in which there
is a high risk of unavoidable or accidental
contact by the operator.
3. In wet or damp hot locations where humidity
or perspiration considerable reduces the
skin resistance of the human body and the
insulation properties of accessories.
B. Environments with increased hazard of electric
shock do not include places where electrically
conductive parts in the near vicinity of the
operator, which can cause increased hazard, have
been insulated.
3.02 Location
Be sure to locate the welder according to the following
guidelines:
A. In areas, free from moisture and dust.
B. Ambient temperature between 0° C to 40° C.
C. In areas, free from oil, steam and corrosive
gases.
D. In areas, not subjected to abnormal vibration or
shock.
E. In areas, not exposed to direct sunlight or rain.
F. Place at a distance of 300mm or more from walls
or similar that could restrict natural air flow for
cooling.
G. The enclosure design of this power source meets
the requirements of IP23S as outlined in AS60529.
This provides adequate protection against solid
objects (greater than 12mm), and direct protection
from vertical drops. Under no circumstances
should the unit be operated or connected in a
micro environment that will exceed the stated