Transtig 300pi – Tweco 300Pi Transtig Welding Inverter User Manual
Page 33
Advertising
TRANSTIG 300Pi
Manual 0-5309
3-15
INSTALLATION, OPERATION AND SETUP
A-12114
Figure 3-7: Setup for Manual Arc Welding
STICK Programming Mode
Programming Parameter
Control Panel Display
Hot Start
This parameter operates in STICK mode
to improve the start characteristics for
stick electrodes
HOT START current is on top of the
BASE current.
e.g. HOT START current = 130 amps
when BASE (WELD) = 100 amps &
HOT START = 30 amps
Range is 0 to 70A. Factory default is
20A. Note that maximum weld current
is 300A.
(Pulse)
A-12115
Advertising