Tweco ProPlus Digital Auto-Darkening Welding Helmet - Manual (Page 11)

ProPlus Auto-Darkening Welding Helmets
Manual 0-5276 11
SECTION 2: Introduction
2.01 How to Use This Manual
This Owner’s Manual usually applies to just the underlined speci-
fication or part numbers listed. If none are underlined, they are all
covered by this manual.
To ensure safe operation, read the entire manual, including the
chapter on safety instructions and warnings.
Throughout this manual, the word WARNING, CAUTION and NOTE
may appear. Pay particular attention to the in formation provided
under these headings. These special annotations are easily recog-
nised as follows:
!
WARNING
Gives information regarding possible personal injury.
Warnings will be enclosed in a box such as this.
CAUTION
Refers to possible equipment damage. Cautions will
be shown in bold type.
NOTE
Offers helpful information concerning certain operating
procedures. Notes will be shown in italics.
2.02 Equipment Identification
The product identification number is printed on the outer shipping
carton. Record this number for future reference.
2.03 Receipt of Equipment
When you receive the equipment, check it against the invoice to
make sure it is complete and inspect the equipment for possible
damage due to shipping. If there is any damage, notify the carrier
immediately to file a claim. Furnish complete information concerning
damage claims or shipping errors to:
CIGWELD, Customer Care Department, 71 Gower St, Preston,
Victoria, Australia, 3072.
Include all equipment identification numbers as described above
along with a full description of the parts in error.
Additional copies of this manual may be purchased by contacting
CIGWELD, Customer Care Department, at the address given above.
Include the Owner’s Manual number and equipment identification
numbers.
SECTION 3: General Information
3.01 ProPlus Digital Auto-Darkening Welding Helmet
ProPlus Digital Auto-Darkening welding helmets are designed to protect the eye and face from sparks, spatter and harmful radiation
under normal welding conditions. After pressing the “ON/ MODE” button, Auto-Darkening filter is ready to use and automatically changes
from a light state to a dark state when an arc is struck, and it returns to the light state when welding stops. The welding helmet will
automatically off after half an hour not use.
The only thing you need to do before your welding is to press the “ON/ MODE” button, adjust the position of the headband and select
the application mode, the correct shade number, the sensitivity, delay for your application.
To ensure your complete satisfaction with your new ProPlus Digital Auto-Darkening Welding Helmet and to realise a safer work environ-
ment, we ask that you read the following Operating Manual thoroughly before use.
3.02 User Responsibility
This product will perform as per the information contained herein when installed, operated, maintained and repaired in accordance
with the instructions provided. This equipment must be checked periodically. Defective equipment should not be used. Parts that are
broken, missing, plainly worn, distorted or contaminated, should be replaced immediately. Should such repairs or replacements become
necessary, it is recommended that such repairs be carried out by appropriately qualified persons approved by CIGWELD. Advice in this
regard can be obtained by contacting an accredited CIGWELD Distributor.
This product or any of its parts should not be altered from standard specification without prior written approval of CIGWELD. The
user of this product shall have the sole responsibility for any malfunction which results from improper use or unauthorised modifica-
tion from standard specification, faulty maintenance, damage or improper repair by anyone other than appropriately qualified persons
approved by CIGWELD.