Tweco VS212 Wire Feeder - Manual (Page 17)

TRANSMIG VS 212
Manual No. 0-4949 2-5 INTRODUCTION
2.07 Features/Benefits
Robust injection molded case
Long lasting and unbreakable.
Changeable MIG gun cartridge system
Patent Pending. No external MIG gun adapters
needed for other style guns with the integrated
cartridge system.
Digital display
Monitor wire speed, amps, volts, arc time and
meter hold. Makes parameter set-up easy.
Heavy duty contactor
Longer life on higher amperage applications.
Internal parts storage
On the job storage for drive rolls, tips, nozzles, etc.
Machined feed head & tension arms
Insures wire alignment tolerances of ±0.05mm.
Inch switch & purge switch
‘Cold’ inching of wire at set wire feed speed and
purging of gas without running wire.
Gun trigger hold (2T/4T)
Allows standard or latched gun trigger.
Heavy duty, removable voltage sensing lead
Allows storage of lead with less lead breakage.
MIG gun holder
A place to hold your MIG gun while not welding.
Lifting eye
Allows for hanging or moving of the feeder over the
work area.
Gas valve solenoid
Controls ‘on/off’ flow of shielding gases.
Wire speed high/low range
Gives a finer dial control of larger diameter flux
cored wires.
Ready to weld
Supplied with 1.2ft (360mm) power cable, Dinse
connector and .035/.045in (0.9/1.2mm) drive rolls
for hard/tubular wire. Geared top & bottom drive
rolls. Excellent traction on the wire.
Quick change drive rolls
Change the drive rolls without tools.