09 rear panel controls and connections, 09 rear panel controls and connections -7, Transmig vs 212 – Tweco VS212 Wire Feeder User Manual
Page 19
Advertising
TRANSMIG VS 212
Manual No. 0-4949
2-7
INTRODUCTION
2.09 Rear Panel Controls And Connections
(1) Lifting Eye
(2) Gas Valve Inlet
(3) Input Power
Cable
(4) MIG Gun Holder
Art # A-07137
Figure 2-3: Rear Panel Connections
1. LIFTING EYE: Allows for hanging or moving of the feeder over the work area.
2. GAS VALVE INLET: This is where the shielding gas hose (if used) is connected to the wire feeder.
3. INPUT POWER CABLE: Provides an inlet and secure fixture for the power cable from the welding power
source.
4. WELDING GUN HOLDER: This is an insulated holder used to hold the welding gun when not welding.
Advertising