Weldskill 100 inverter, 08 setup for tig welding, 240v ac power source – Tweco 100 Weldskill User Manual
Page 21: Figure 3-4: set-up for tig welding
Advertising
weldskill 100 iNVeRTeR
3-5
March 3, 2008
3.08 Setup For TIG Welding
!
WARNING
Before connecting the work clamp to the work and inserting the electrode in the TIG torch make
sure the Mains power supply is switched off.
CAUTION
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the
Welding Power Source.
240V AC POWER SOURCE
Art # A-08373_AC
NEGATIVE
OUTPUT
TERMINAL
POSITIVE
OUTPUT
TERMINAL
Set Process
Selection Switch to
LIFT TIG mode
WeldSkill
10
15
20
30
40 50
60
70
80
90
100
Figure 3-4: Set-up for TIG Welding
Advertising