07 setup for tig welding, Weldskill 170 hf inverter – Tweco 170 HF Weldskill User Manual
Page 21
Advertising
WELDSKILL 170 HF INVERTER
3-5
April 23, 2008
3.07 Setup For TIG Welding
!
WARNING
Before connecting the work clamp to the work and inserting the electrode in the TIG torch make
sure the Mains power supply is switched off.
CAUTION
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the
Welding Power Source.
Art # A-08438_AB
NEGATIVE
OUTPUT
TERMINAL
POSITIVE
OUTPUT
TERMINAL
Set Process
Selection Switch
to LIFT TIG/HF
TIG mode
as required
Figure 3-2: Set-up for TIG Welding
Advertising