Unitec Sentine Owner’s Manual - Manual (Page 78)

S E N T I N E L
Document Number: SENT1002 68
Document Title: Sentinel Owner Manual
1 0 . 4 . 1 . 5 C l e a n i n g a n d G e n e r a l M a i n t e n a n c e
The AE2600 series will not need cleaning as often as magnetic sensing bill validators. If cleaning is
required, use a soft cloth moistened with mild, non-abrasive detergent.
1 0 . 4 . 1 . 6 P r o g r a m m i n g t h e M a r s B i l l V a l i d a t o r
WARNING: The DIP Switch settings are preconfigured at the factory, and should not be modified.
The Mars Bill Validator allows programming for a maximum-security setting, as well as a setting for a
specified direction that a bill can be inserted. These options are set by a Dipswitch package located on one
side of the validator.
To change any of the options, perform the following steps.
1. Remove the Mars Bill Validator from the unit. (See Removing the Mars Bill Validator for
instructions.)
2. Referring to Table 7, use a small flat-head screwdriver to set the Dipswitches for the
options you prefer. (See the following figure for dipswitch location.)
Figure 60. Mars DIP Switches