Unitec Sentine Owner’s Manual - Manual (Page 82)

S E N T I N E L
Document Number: SENT1002 72
Document Title: Sentinel Owner Manual
The Coin Acceptor accepts tokens ranging in size from .984” – 1.125” in diameter. When programming
site-specific tokens, it is important that you take into consideration the following items:
Tokens with a diameter of .984” are commonly used at nationwide arcade/pizza stores. The IDX coin
acceptor will accept these tokens if your site-specific token is the same size.
Compare your token size with any local arcade tokens prior to programming the IDX coin acceptor to
accept your site token.
The IDX acceptor can be programmed to accept up to four different tokens. The value for each token is
programmed in the device profile based on how many pulses are sent on the token line.
To program the IDX to accept a single token, follow the instructions below.
1. Set the rotary-switch to position 1, 2, 3, or 4.
2. Press the button immediately to the left of the rotary-switch one or more times depending
on the number of pulses you want that token to send.
3. Drop six sample tokens through the coin slot one at a time, and verify that the red light
(LED) blinks several times after the last token has been entered.
4. Reset the rotary- switch to “0” and replace the front cover.
If more tokens are required, refer to Programming the IDX Acceptor to get the switch locations for that
particular token, and then press the push-button the number of times that is equal to the number of
pulses to be sent for that token.
10.6.5 Erasing IDX Programming
If you need to erase programming or start over, use the following procedure:
1. Remove the front cover from the IDX acceptor.
2. Set the rotary switch to the position that corresponds to the coin you wish to re-program or
erase.
3. Depress the button located immediately to the right of the rotary switch only once.
4. Return the rotary switch to zero without passing any coins through the acceptor. This will
erase the program that has been stored for that number.
5. Return the front cover to the IDX.
10.7 Coin Hopper(s) (Optional)
The Sentinel is can be equipped with up to 3 Suzo Mark II coin dispensers, which is embedded in a
proprietary Unitec design. The dispenser is able to hold/dispense up to 2,400 quarter-sized coins. It is
located inside the SentineI case in the vault on the upper right.
10.7.1 Removing the Hopper Tray
To remove your hopper, slide the hopper tray forward. Filling the Hopper