VICI FTP - Manual (Page 9)

5
Getting Started
Viewing the Command Set
To view the list of commands for the FTC, type ??<enter>. All HyperTerminal commands
must be followed by <enter> on the keyboard. Characters may be in either upper or
lower case. You may wish to print the list for for reference.
A+ Enable autocorrection
A- Disable autocorrection
CC Connect column
CD Disconnect column
CI Calibrate current scale
CR Calibrate column resistance
CV Calibrate voltage scale
D+ Debug on
D- Debug off
DD Dump data
DR Dump ram
DX Dump parameters to Xml
E+ Terminal echo on
E- Terminal echo off
EC Enter R(t) calibration data
EM Enter MPC parameters: [offset [skip]]
ES Enter state data
ET[=n] Show/set equilibration time (seconds)
F+ Fan on
F- Fan off
FM[=n] Show/set fan mode: [0]off, [1]on, [2]temp, [3]time
FT[=n] Show/set fan temp (°C) / time (seconds)
GO Start ramp/cooling cycle
L+ Start data logging
L- Stop data logging
LA[=n] Show/set matrix lambda
RR Read column resistance
RS Reset state machine
RT Read column temperature
RX Read parameters from Xml. Use flow control!
SR Run step response test
SS[n] Show/set state (n=1-8) parameters
VR Show firmware version
WP Write eprom parameters
Z- Turn off column heating
Z+ Turn on column heating
?? Show this list