VICI TCD2 User Manual
Page 6
2
Safety Notes and Information
Symbols
HOT SURFACE
The surface of the detector body may be hot while in
operation (possibly in excess of 250°C). Observe caution.
ATTENTION
Refer to the manual.
PROTECTIVE EARTH
This internal connection provides protection against electric
shock from mains voltages and should not be removed.
Installation Category
This equipment has been designed for installation category (overvoltage
category) II, pollution degree 2. It has been approved for use only in heavy
industrial environments and may not be used in the residential, commercial,
or light-industrial environment.
Safety
This instrument has been designed and tested in accordance with the
product safety standard, EN61010. It has left the factory in a safe
condition. This instruction manual contains important information and
warnings which must be followed by the user to insure safe operation and to
retain the instrument in a safe condition. The case, chassis, and measuring
terminals are connected to the protective earth contact of the mains inlet.
The instrument operates with a three-conductor power cord having a pro-
tective earthing conductor and a plug with an earthing contact. The mains
(line) plug shall only be inserted in a socket outlet provided with a protective
earth contact. The protective action must not be negated by the use of an
extension cord without a protective conductor. Use only with an approved
mains supply cord having a rating of 2A, 250V, or greater. Do not use this
equipment in a manner not specified herein.
Maintenance
The exterior of the instrument should be cleaned regularly with a dusting
brush. If necessary, the casing can be cleaned with a moistened cloth
(99% water + 1% mild detergent). Spirit or petroleum ether can be used
to remove greasy dirt. Any other cleaning agents can attack the plastic
and painted surfaces.
Under no circumstances should the cleaning fluid get into the instrument.
Petroleum ether is flammable, and care should be taken in its use.
The detector must be returned to the factory when filament replacement is
required. Call VICI Tech Support for return authorization.
Introduction