Waring MX1500XTXP - Manual (Page 3)

3
MX MECHANICAL SwITCHES
1. Before starting, make sure that the blender is
unplugged and container is not positioned on
the blender.
2. Put ingredients into container and cover it. Do not
fill above MAX line.
3. With the unit in STANDBY position, place
container on blender base. Be sure container is
fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
4. This blender has 2 speed settings: HI and LO . Press Paddle Switch
to desired position. To crush ice quickly, use HI speed setting.
5. When finished blending, set paddle switch to STANDBY position.
6. This blender is equipped with a PULSE option. Hold paddle switch
down to engage PULSE function. Unit will run on HI speed until the
paddle switch is released.
7. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
8. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
9. Wash and dry container after each use. See Cleaning and Sanitizing
instructions.
MX ELECTRONIC TOUCHPAD SwITCHES
wITHOUT SOUND ENCLOSURE
1. Before starting, make sure that the blender is
unplugged and container is not positioned on
the blender.
2. Put ingredients into container and cover it. Do not
fill above MAX line.
3. Place container on blender base. Be sure container
is fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
4. This blender is equipped with an electronic membrane keypad. The key-
pad has a main power STANDBY button, plus HI , LO , STOP and
PULSE buttons.
5. Press the STANDBY button to turn on the blender. Green LED will
illuminate. For continuous operation, press either LO or HI button.
When finished blending, press STOP . For momentary operation,
press the PULSE button; motor will run on HI speed until the
button is released.
NOTE: Your MX Electronic Blender uses a Slow Start
™
feature. When
pressing HI , the unit will start in the LO speed for 2 seconds and
then switch to HI speed. This allows for a more even blending of ingre-
dients in container.