Waring MX1500XTXP - Manual (Page 4)

4
6. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
7. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
8. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
9. To turn unit off, press STANDBY button. Green LED light will go off.
MX ELECTRONIC TOUCHPAD SwITCHES wITH TIMER
1. Before starting, make sure that the blender is
unplugged and container is not positioned on
the blender.
2. Put ingredients into container and cover it. Do not
fill above MAX line.
3. Place container on blender base. Be sure container
is fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
4. This blender is equipped with an electronic membrane keypad. The
keypad has a main power STANDBY button, plus HI , LO , STOP
and PULSE buttons and a 30-second countdown timer with up
and down arrows to set time.
5. Press the STANDBY button to turn on the blender. Green LED will
illuminate. The electronic timer will indicate 10 seconds (default). Press
the up or down arrow to set the desired time. The electronic
timer will indicate run time in 5-second intervals up to a maximum of 30
seconds. After the desired time is set, press HI or LO to start the
blender. The timer will count down to 0 in 1-second intervals and blend-
er will shut off. Pressing the PULSE button, the STOP button or
the STANDBY button will override the timer and the blender will stop
regardless of time left on timer.
NOTE: If you want to increase or decrease time while timer is counting
down, press up or down arrows. Time will increase or decrease in
5-second intervals.
6. If the blender is not used for five seconds, the timer function will turn
off and return to manual mode. To reactivate timer, press up or down
arrows. When using the electronic timer again, the initial time will
be the last time set. Note: If unit has been turned off or unplugged, the
timer will default back to 10 seconds.
7. For continuous operation, press either LO or HI button. When
finished blending, press STOP . For momentary operation, press
the PULSE button. Motor will run on HI speed until the button is
released.
NOTE: Your MX Electronic Blender uses a Slow Start ™ feature. When
pressing HI , the unit will start in the LO speed for 2 seconds and
then switch to HI speed. This allows for a more even blending of
ingredients in container.