Waring MX1500XTXP - Manual (Page 6)

6
4. The motor speed can be adjusted by pressing the or Speed
buttons. Speed ranges from 15% to 100%.
100% 20,000 RPM
50% 10,000 RPM
15% 3,000 RPM
The Speed Up button will increase the motor speed display in 1%
increments and the Speed Down button will decrease the motor
speed display in 1% increments. Holding down either button will quickly
scroll through speeds.
Using the Speed Up and Speed Down buttons, set desired motor
speed. If no speed is selected, motor will default to 100%.
NOTE: The motor does not run at the newly set speed until the START/
STOP button is pressed. If START/STOP button is not pressed
within 5 seconds, the new speed setting will be stored for next use and
the blender will return to STANDBY mode; the display will once again
read “PRESS ANY BUTTON TO BLEND”.
5. Press START/STOP button to run the blender. Blender will run
continuously at the set speed. The LCD will display the motor speed in
percentage. Default speed (percentage) is at 100%. Motor speed can be
changed while blender is running by simply pressing Speed Up
or
Speed Down button.
6. To stop continuous blending operation, press START/STOP button or
press any of the program buttons.
PULSE FEATURES
Your unit comes equipped with two PULSE options: Normal Pulse
and
Maximum Pulse . Note: The Pulse buttons are momentary switches –
once released, the unit will shut off.
1. To use Max Pulse option, press the
button. This will run the motor
at 150% speed. The LCD will read “MAX PULSE SPEED: 150%”.
2. To use Normal Pulse option, press the
button. This will run the motor
at 100% speed. The LCD will read “NORM PULSE SPEED: 100%”.
3. The blender allows you to set the pulse to your desired speed. While
blending at Normal Pulse speed, the motor can be adjusted. To do this,
hold the Normal Pulse
button and press Speed Up
or Speed
Down button to adjust the blending speed. The LCD will show the
setting speed and motor speed will change.
NOTE: The speed can be set from 15% to 100%. Once the
Pulse
button is released, the motor will shut off and the blender will return to
standby mode. The changed pulse speed will be stored in memory to
replace the default speed at 100%.