Winchester Repeating Arms Super X2 (Historic Manual) - Manual (Page 27)

27
closed position. To do this hold the bolt handle with one
hand while depressing the carrier release button with the
other to prevent slamming the bolt forward and damaging
the receiver.
3. Remove the trigger group as explained under “Trigger
Group Disassembly/Reassembly.”
4. Remove the bolt handle by pulling the handle outward,
to the right, away from the bolt. It is held in place with a
ball-detent system that may take a little effort to pull free.
5. Slide the bolt and bolt slide forward and out of the
front of the receiver (See Figure 19).
6. The bolt and bolt slide can be separated for cleaning
(See Figure 20). Perform any cleaning of the bolt and
receiver cavity as necessary.
DO NOT DISASSEMBLE THE BOLT ASSEMBLY
BEYOND THIS POINT.
H OW TO REINSTALL THE BOLT ASSEMBLY —
Under usual conditions, the trigger group should also
have been removed at this point. Reinstallation of the
bolt assembly is somewhat easier with the trigger group
removed.
1. Reassemble the bolt and bolt slide as shown
(See Figure 21).
2. Place the bolt assembly back in the receiver, bolt slide
link end first (See Figure 22). Line the rails on the bolt
slide with slots in the bottom of the receiver.
3. Guide the bolt slide link into its socket in the recoil
FIGURE 19 FIGURE 20
Separate the bolt and bolt slide for easy cleaning.
Remove the bolt assembly forward,
out the front of the receiver.
Bolt
Bolt Slide