Winchester Repeating Arms Super X2 (Historic Manual) - Manual (Page 30)

30
I NVECTOR ® P LUS C HOKE T UBE S YSTEM
The Super X2 is fitted with one of the most popular and
universally accepted choke tube systems on the market:
Invector-Plus. Your Super X2 Shotgun is specially
designed for this system only. This means:
• It has a back-bored barrel.
• It is threaded to accept Invector-Plus choke tubes only.
The Invector-Plus system allows you to configure your
Super X2 for the pattern and/or choke constriction your
hunt demands. The system gives you the most highly
engineered choke tapers — designed to produce the best
possible patterns for target and field situations. Plus, it is
extremely easy to switch choke constrictions to match
your shooting conditions. Invector-Plus tubes are fully
steel and lead shot compatible. Most Invector-Plus choke
tubes fit flush with the muzzle when installed. A special
choke tube wrench is provided to remove and tighten
these tubes.
Invector-Plus choke tubes are NOT interchangeable with
any other choke tubes on the market including chokes
listed as "Standard Invector" or Winchester’s current line
of "WinChoke" choke tubes.
USE ONLY CHOKE TUBES MARKED INVECTOR
PLUS IN YOUR SUPER X2. USE ONLY THE
APPROPRIATE GAUGE OF INVECTOR PLUS
CHOKE TUBES AS MARKED ON YOUR
SUPER X2 SHOTGUN.
Failure to follow these warnings may damage your gun
and cause injury to yourself and others. A special "Plus"
choke tube wrench is provided to remove and tighten
Invector-Plus choke tubes.
DO NOT FIRE THIS SHOTGUN WITHOUT
HAVING AN INVECTOR CHOKE TUBE
INSTALLED. PERMANENT DAMAGE MAY
RESULT TO THE THREADS.
CAUTION: WHENEVER HANDLING ANY SHOT-
GUN FOR THE PURPOSE OF REMOVING OR
INSTALLING A CHOKING DEVICE, MAKE
ABSOLUTELY CERTAIN THE GUN IS FULLY
UNLOADED, AND THE BOLT OR BREECH IS
OPEN! NEVER ATTEMPT TO REMOVE OR
INSTALL A SHOTGUN CHOKING DEVICE ON
A LOADED FIREARM!
T UBE REMOVAL —
1. UNLOAD YOUR SUPER X2 SHOTGUN
FULLY. INSPECT THE CHAMBER, FEED
MECHANISM AND MAGAZINE TO MAKE SURE
THEY DO NOT CONTAIN ANY SHELLS.