OSRAM SYLVANIA LEDstixx - Manual (Page 4)

4
Figure 4
1.4.3 Position connector side of LEDstixx up or down depending on the direction of preferred power routing. Please refer to section 1.5.6.
1.4.4 Press the LEDstixx unit into the Mounting Bracket “U” channel, between the two end caps of the LEDstixx unit, with the lens
portion facing inside the cooler (Figure 4). Verify that the LEDstixx unit snaps tightly into the “U” channel of the Mounting Bracket.
1.4.5 Connect the Positive (Red) wire from the LEDstixx wire harness with the 24VDC wire coming from the OT75 power supply wire
harness. Connect the Negative (Black) wire from the LEDstixx wire harness with the negative from the wire harness coming from the
OT75 power supply. Note the green and white wires in the LEDstixx wire harness are for dimming system applications. Properly cap
off these wires if not being used. (See Figure 14 for Wiring Diagram)
1.4.6 Secure the cable to the mullion/cooler wall. Slide the cable cover over the end of the LEDstixx to cover the wire harness entry
to the mullion
1.4.7 Energize.
Figure 2