Quoizel TF1784VB Tiffany User Manual

Illustrationa illustration b

Advertising
background image

FIXTURE LOOP

SMALL LOOP

SIDE CHAIN

PLATE

DIFFUSER

BULB(not supplied)

JUNCTION BOX

SOCKET

HEX COUPLING

NIPPLE with HEX NUT

1/8 IP. NIPPLE

HOOK

SHADE

CAP

FINIAL

SHADE HOLDER

DIFFUSER

LOCK BALL

WASHER

PLATE

ILLUSTRATIONA

ILLUSTRATION B

IS TF1784

Page 1 of 3

Revised 2006 12-19

-

-

6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com

,

.

.

.

NOTE: DUE TO THE HANGING WEIGHT OF THIS FIXTURE, QUOIZEL
HIGHLY RECOMMENDS YOU CONSULT A LICENSED ELECTRICIAN
OR QUALIFIED CONTRACTOR FOR THIS INSTALLATION.
QUOIZEL RECOMMENDS (2) PEOPLE FOR THIS INSTALLATION

CEILING INSTALLATION INSTRUCTIONS
FOR FIXTURES WEIGHING OVER 45 LBS.

1. Before beginning fixture assembly, carefully unpack all of the parts referring to the illustration for parts

identification.

2. Turn the power to installation point OFF at the circuit breaker.
3.Locate the Nipple with Hex Nut. Thread the top end of the Nipple into the Hex Coupling underside of the

Junction Box and leave the 1/8 IP. Nipple towards down. Use the plier, thread the Hex Nut against the
Hex Coupling and hand tighten until snug.

4.(Refer to the ILLUSTRATION B) Position the Diffusers and make the holes on them over the Studs on

the Plate. Place the Washers over the Studs and thread the Lock Balls onto the Studs to scure them.
Hand tighten until snug.

5.

Put one end of the Side Chain onto the Small Loop on the side of the Fixture Canopy. With another
people, lift the Shade upward and make the hole on the bottom center over the 1/8 IP. Nipple. Place
another end of the Side Chain onto the Hooks on the top edge of the Shade. And then position the
Shade Holder inside of the hole on the bottom of the Shade and locate the Cap over the Shade
Holder. Secure them with the Finial and tighten until snug.

6.

7. Install the correct bulbs referring to fixture markings and/or labels for maximum wattage.
8. Restore power to the installation point ON. Retain this sheet for future reference.

:

STOP HERE! YOU MUST NOW REFER TO PAGE 2 FOR SPECIFIC CEILING MOUNT INSTALLATION

INSTRUCTIONS AND PAGE 3 FOR SAFETY CABLE INSTALLATION INSTRUCTIONS.

Quoizel recommended two people for this step

Advertising