Quoizel GE351SE Genova - Manual

NIPPLE
(2)OUTLET BOX SCREWS
(not supplied)
CROSSBAR
OUTLET BOX
HOUSE SUPPLY and
GROUND WIERS
GREEN GROUND SCREW
CEILING CANOPY
KNOB
FIXTURE CHAIN
FIXTURE LOOP
FIXTURE CANOPY
SUPPORT RODS
HOOK
CENTER STEM
RING
JUNCTION BOX
SOCKET
SHADE HOLDER
SHADE
SOCKET COLLAR
ASSEMBLY/INSTALLATION INSTRUCTIONS:
Tools required for installation: Slotted screwdriver, Pliers, Wire Cutters, Wire connectors and Electrical tape.
1.Carefully unpack all parts referring to illustration FIGURE1 for parts identification.
2.Turn power to the installation point OFF at circuit breaker.
3.Thread the end of the CENTER STEM onto nipple on the top center of JUNCTION BOX. Hand tighten
until snug. Proceed to locate the top ends of the SUPPORT RODS onto HOOKS and locate the other
ends onto the RINGS.
4.Locate the ends of FIXTURE CHAIN onto the FIXTURE LOOPS. Depending on the chain
material, you might need pliers to spread the links.
5.Locate the CROSSBAR and attach to ceiling mounted outlet box using (2)OUTLET BOX SCREWS
(not supplied). Locate the NIPPLE with HEX NUTS and SHAKE PROOF WASHER. Pass the SHAKE
PROOF WASHER over the end of the NIPPLE and thread NIPPLE into the center of the CROSSBAR.
Using pliers, tighten HEX NUT against CROSSBAR to secure NIPPLE.
6.Make the connections: Quoizel recommends a minimum of (2)people for the next (2)steps. Trim
the FIXTURE SUPPLY and GROUND WIRES to approx. 6" in the length from where the wires exit
CEILING CANOPY. Trim back wire jacketing approx. 3/4". Position the fixture under the OUTLET
BOX. Using wire connectors(not supplied)connect the HOUSE GROUND WIRE to FIXTURE
GROUND WIRE; connect the HOUSE WHITE WIRE to the FIXTURE SUPPLY WIRE(RIBBED
SIDE); connect the HOUSE BLACK (or RED)WIRE to the FIXTURE SUPPLY WIRE(SMOOTH SIDE).
Wrap each connection with approved electrical tape.
7.With the connections properly made, carefully tuck all wires into OUTLET BOX. Pass the MOUNTING
HOLE in the underside of the CEILING CANOPY over the NIPPLE, attach to CROSSBAR. Thread
HEX NUT onto the end of the NIPPLE. Hand tighten HEX NUT to secure fixture against the ceiling.
Proceed to thread the FINIAL onto the end of the NIPPLE and hand tighten until snug.
8.Locate SHADES over SOCKETS onto SHADE HOLDERS. Secure by threading SOCKET
COLLARS onto SOCKETS and hand tighten until snug. Install bulbs referring to fixture markings
and/or labels for maximum wattage.
9.Restore power to installation point ON. Keep this sheet for future reference.
FIGURE1
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!
IS-GE351
12.05
6 CORPORATE PARKWAY
GOOSE CREEK, SC. 29445
www. quoizel. com