Quoizel TL184EP Tradewinds - Manual (Page 2)

Nipple
Hex Nut
Ceiling Canopy
2 OF 3
Nipple Ceiling Canopy
Flat Washer Lock Washer
Hex C oupling
Stem with Hex Nut
STEP 2 :
a. Thread another Hex Nut onto the other end of the
nipple. Thread this Hex Nut on just enough so the
inside surface of the pan rests against it.
You may have to trial fit the Ceiling Canopy one more
times to insure this distance also. This Hex Nut is
needed here to prevent you from crushing down the
center of the Ceiling Canopy
*
.
WHITE OR RIBBED
BLACK OR RED WIRE ( )
FROM HOUSE
GROUND WIRE GROUND WIRE
FROM HOUSE FROM FIXTURE
WHITE OR RIBBED
FROM FIXTURE FROM HOUSE
FROM FIXTURE
BLACK OR SMOOTH
STEP 3 :
* ( )
.
.
. ( )
( )
. ( )
( ).
.
.
Use Wire Connectors not supplied to connect the
wires
a Connect the House Ground Wire to the Fixture Ground
Wire.
b Connect the House White or Ribbed Wire to the
Fixture Supply Wire White or Ribbed Side .
c Connect the House Black or Red Wire to the Fixture
Supply Wire Black or Smooth Side
d Wrap each connection with approved electrical tape and
carefully stuff all of the connected wires into the Outlet
Box
STEP 4 :
.
.
*
a Position the Ceiling Canopy to the ceiling by . passing
the Nipple through the center hole
b Slip on the Flat Washer and the Lock Washer and then
thread the Hex Coupling to the bottom end of the Nipple
Snug down assembly until the Ceiling Canopy is flush
against the ceiling
Be sure that there are no trapped or pinched wires
along the edge of the pan.
.
.
STEP 5 :
a Thread the Hex Nut end of the Stem into the Hex Coupling
underside of the Ceiling Canopy. Using pliers, thread the
Hex Nut against the Hex Coupling, hand tighten until snug.
.
Hex Coupling Ceiling Canopy
STEP 6 :
a. Install correct Bulb(s) referring to fixture markings and/or labels for maximum wattage.
INSTALLATION INSTRUCTIONS FOR FLUSH MOUNTS OF AL-LL-ML-TL GROUPS