Quoizel TF1804SVB Tiffany - Manual (Page 2)

2of2
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc. April2014
TF1804SVB
PART NUMBER
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2 "
REPLACEMENT PART DESCRIPTION REQ. NO.
(2) 75W
Bulbs
(Not Supplied)
Medium
Base
1
FINISH: VINTAGE BRONZE
16.5” Dia.
4”
6”
15.5” Dia.
White wire
from supply
Ribbed side wire
from fixture
Black wire from
supply (or Red) Smooth side wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 3
C. Connect Black (or Red) Supply Wire from the Outlet Box to Smooth
side Wire from fixture.
D. Connect Ground Wire from the Outlet Box to Ground Wire from
fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 4
STEP 6 Install Shade -
A. Locate the Shade (B) wedge in the two Shade Holders without
Spring. Pull the one Shade Holder with the Spring outside and
position the Shade (B) onto the bottom of the Ceiling Canopy (A).
The Shade Holder will engage the Shade (B) after release.
STEP 5 Install Bulb -
A. This fixture uses standard bulb with medium screw base. Maximum
75 watts.
B. Insert bulb and screw snugly into place.
Bulb
Figure 6
Figure 5
Socket
STEP 4 Attach Ceiling Canopy -
A. Position the Ceiling Canopy (A) and
Flat Washer (EE) to the ceiling by
passing the Nipple (DD) through the
center hole. Thread the Finial (C) to
the bottom end of the Nipple (DD).
Snug down assembly until the
Ceiling Canopy (A) is flush against
the ceiling.
* Be sure that there are no trapped
or pinched wires along the edge of
the Ceiling Canopy (A).
AA
A
C
DD
EE
Shade Holder
A
B
Shade Holder
G3826SH SHADE TIFFANY 16"D x 4”H 1
1
7” Dia.