Quoizel TFIK1714VA Inglenook User Manual

Quoizel Lighting

Advertising
background image

SUPPLY WIRE and

GROUND WIRE

UNIVERSAL CROSSBAR

( )

2 MOUNTING SCREWS

( )

(

)

2 OUTLET BOX

SCREWS

not supplied

FIXTURE CANOPY

( )

2 MOUNTING BALLS

SOCKET

HEX COUPLING

SPACER TUBE

CHECK RING

NIPPLE with KNURLED

NUT and HEX NUT

PLAIN WASHER

SHADE

FINIAL

6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com

,

.

.

.

ASSEMBLY / INSTALLATION INSTRUCTIONS

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!

IS TFIK1714

Revised 2009-03-06

-

1 Before beginning the installation

carefully unpack and identify all parts

referring to

the illustration

2 Turn the electrical power to installation point OFF at circuit breaker

3 Remove KNURLED NUT from the NIPPLE and thread the HEX NUT end of the NIPPLE

into the HEX COUPLING underside of the JUNCTION BOX

Using plier, thread HEX

NUT against the HEX COUPLING and hand tighten until snug. Proceed to pass the
SPACER TUBE and the CHECK RING over the end of the NIPPLE

Secure with the

KNURLED NUT and hand tighten until snug

4 Locate the PLAIN WASHER and SHADE over the end of the NIPPLE and secure with

the FINIAL. Hand tighten until snug

5 Locate the

2 MOUNTING SCREWS and thread them into the back of the

UNIVERSAL CROSSBAR

making sure that they match the holes in the FIXTURE

CANOPY

Using

2 OUTLET BOX SCREWS not supplied

fasten the UNIVERSAL

CROSSBAR to the OUTLET BOX

6

Using wire connectors not supplied

connect the

HOUSE GROUND WIRE to the FIXTURE GROUND WIRE

connect the HOUSE

WHITE WIRE to the FIXTURE SUPPLY WIRE

WHITE or RIBBED SIDE

connect

the HOUSE BLACK

or RED

WIRE to the FIXTURE SUPPLY WIRE

BLACK or

SMOOTH SIDE

Wrap each connection with approved electrical tape

7 Carefully tuck all of the wiring up into the outlet box

and fit the FIXTURE CANOPY

over the MOUNTING SCREWS

Secure the FIXTURE CANOPY to the ceiling with

the 2 MOUNTING BALLS

making sure that the balls are fully threaded onto the

MOUNTING SCREWS before tightening

8 Install bulbs referring to fixture markings and or labels for maximum wattage

9 Restore power to installation point ON

Retain this sheet for future reference

.

,

,

.

.

.

.

( )

,

.

( )

(

),

.

.

.

,

.

( )

,

.

.

.

.

.

.

.

.

.

.

.

(

)

;

(

);

(

)

(

).

.

/

.

MAKING THE CONNECTIONS:

Advertising