Quoizel TF9404M Tiffany - Manual

FINIAL
DIFFUSER
SHADE
STEM WITH
KNURLED NUT
CHECK RING
SPACER
BULB not supplied ( )
COUPLING
BASE
SHADE
SOCKET COLLAR
SOCKET
SHADE
HOLDER
TASK LAMPS
HARDBACK SHADE W/ TOP DIFFUSER
Locate the hole in the SHADE over the SOCKET so it sets
onto the SHADE HOLDER. Thread the STEEL COLLAR (*)
and SOCKET COLLAR onto the socket. Hand tighten until
snug. Install the bulb(s) referring to the fixture markings
and/or labels for maximum wattage.
This instruction can also be
applied to table top torchieres
where the shade is
inverted and faces
upward.
Remove the KNURLED NUT from the STEM and then
thread end of STEM into COUPLING on the top center of
socket body. Hand tighten until snug. Position SPACER
and CHECK RING downwards over top end of STEM and
thread KNURLED NUT until snug to secure them. Locate
SHADE and DIFFUSER over top end of STEM. Secure
them by threading FINIAL onto the top end of STEM.
Hand tighten until snug. Install bulb(s) referring to
fixture markings and/or labels for maximum wattage.
STEEL COLLAR
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
UPPER
SECTION
ELECTRICAL
CORD
LOWER
SECTION
ASSEMBLY
INSTRUCTIONS
Place lamp base onto a flat
surface. Thread UPPER
SECTION and LOWER
SECTION together and
hand tighten until snug.
Note: depend on style
purchased, lamps may be
divided into more than
(2)sections and may or
may not have lamp base
joined to end of LOWER
SECTION. Join all
sections together.
NOTE: PLEASE TAKE SPECIAL
CARE NOT TO PINCH OR CUT
THE ELECTRICAL CORD WHEN
JOINING THE SECTIONS.
DECORATIVE RING
OR TRIM
SOCKET
SHADE HOLDER
BULB
SHADE
SOCKET COLLAR
3 MOUNTING DISC "
TORCHIERE GLASS
Position the SHADE/GLASS and the 3“ MOUNTING
DISK(*) over the SOCKET. Thread the SOCKET
COLLAR onto the SOCKET and hand tighten until snug
to secure them. Install the bulb(s) referring to the fixture
markings and/or labels for maximum wattage.
Position the DECORATIVE RING/TRIM(*) onto the
outside edge of the SHADE/GLASS.
TORCHIERE & FLOOR LAMP
TUBE SECTIONS
NOTE: A PART DESCRIPTION FOLLOWED BY AN ASTERISK (*)
MAY OR MAY NOT BE INCLUDED IN YOUR STYLE OF LUMINAIRE.
*
*
NOTE: A PART DESCRIPTION FOLLOWED BY AN ASTERISK (*)
MAY OR MAY NOT BE INCLUDED IN YOUR STYLE OF LUMINAIRE. NOTE: A PART DESCRIPTION FOLLOWED BY AN ASTERISK (*)
MAY OR MAY NOT BE INCLUDED IN YOUR STYLE OF LUMINAIRE.
BEFORE BEGINNING ASSEMBLY/SHADE INSTALLATION, CAREFULLY UNPACK
ALL PARTS AND REFER TO THE ILLUSTRATIONS FOR PARTS IDENTIFICATION.
THIS INSTRUCTION SHEET COVERS A VARIETY OF LAMPS AND SHADE
APPLICATIONS. DO NOT PLUG IN YOUR LAMP TO A POWER SOURCE UNTIL
ALL ASSEMBLY AND BULB INSTALLATION IS COMPLETE.
*