Quoizel TFMT6320IB Marietta User Manual
Warnings and cautions, Package contents, Care of tiffany style shade
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC 29445
Customer Service
Phone 631.273.2700
Fax
631.231.7102
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape,
safety glasses.
Estimated Assembly Time: 10-15 minutes
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams
below to be sure all parts are present. If any parts are missing or damaged, do not attempt to assemble, install, or
operate the fixture. Contact customer service for replacement parts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-TFMT6320IB
For Style TFMT6320IB
Bulb Recommended: (2) Medium Base 75W Maximum, Alternate bulb (2) 19W CFL
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,
.
.
.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at
2014 QuoizelInc.
May2014
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
B
A
Base
x 1
Shade
x 1
Care of Tiffany Style Shade
A new tiffany lamp shade has an oil film applied to the shade that protects the tiffany shade from scratches during shipment. If the oil applied is
too heavy you can remove the excess oil film with a paper towel. Gently wipe away the excess oil.
For general cleaning of tiffany shades use a gentle lemon oil-based furniture polish applied to a soft cloth and wipe gently.
If a white powder appears on the soldered joints of the tiffany shade this is a normal oxidation process. Use a small amount of lemon oil or
mineral oil applied directly to oxidized areas and the soldered area will return to like new.
STEP 2
Install Shade
-
A. Attach the Spacer Tube (E), the Check
Ring (D) and the Shade (A) over the
top end of the Stem (F) as shown.
Secure by threading the Finial (C)
onto the Stem (F). Hand tighten until
snug.
Figure 2
C
D
STEP 3
Install Bulb
-
A. This fixture uses standard bulb with
medium base . Maximum 75 watts.
B. Insert bulb and screw snugly into
place.
Your fixture is now assembled and
ready to use. Enjoy!
Figure 3
C
Check
Ring
x 1
Spacer Tube
x 1
D
E
Finial
x 1
Stem with
Hex Nut
x 1
F
STEP 1
Install Stem with Hex Nut
-
A. Thread the Hex Nut end of the Stem
(F) into the Hex Coupling on the top
center of the Base (B). By using
pliers, thread the Hex Nut against the
Hex Coupling and hand tighten until
snug.
Figure 1
F
B
Hex
Coupling
E
F
A
Socket
Bulb
Bottom View