Quoizel QJ6781TR Quoizel Lamp - Manual

Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC 29445
Customer Service
Phone 631.273.2700
Fax
631.231.7102
www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape,
safety glasses.
Bulb Recommended:
Estimated Assembly Time:
Preparation:
(2) Medium Base 60W Maximum, Alternate bulb (2) 13W CFL
10-15 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams
below to be sure all parts are present. If any parts are missing or damaged, do not attempt to assemble, install, or
operate the fixture. Contact customer service for replacement parts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-QJ6781TR
For Style QJ6781TR 6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc. June2014
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
B
A
Base
x 1
Shade
x 1
STEP 3 Install Shade -
A. Thread the Big Knurled Nut onto the
Stem (I) and adjust to proper location
for rest components.
B. Place the Flat Washer (G), the Rubber
Washer (H), the Shade (A) and the
Cap (D) over the Stem (I) in turn.
Secure by threading the Finial (C)
onto the Stem (I). Hand tighten until
snug.
Figure 2
C
STEP 4 Install Bulb -
A. This fixture uses standard bulb with
medium base. Maximum 60 watts.
B. Insert bulb and screw snugly into place.
Your fixture is now assembled and ready
to use. Enjoy!
Figure 4
C
Check Ring
x 1
Spacer Tube
x 1
E
F
Finial
x 1
Stem with
Knurled Nuts
x 1
I
STEP 1 Install Stem with Knurled Nuts -
A. Remove the Knurled Nuts from the Stem (I).
B. Thread the hex nut end of the Stem (I) into the
Hex Coupling on the top of the Base (B). By
using pliers, thread the hex nut against the
Hex Coupling. Hand tighten until snug.
Figure 1
B
Hex
Coupling
A
Socket
Bulb
Bottom View
STEP 2 Install Spacer Tube -
A. Place the Spacer Tube (F) and the Check
Ring (E) over the Stem (I) and secure with
the Small Knurled Nut. Hand tighten until
snug.
Small
Knurled
Nut
Big
Knurled Nut
Figure 3
Cap
x 1
D
Flat
Washer
x 1
G
Rubber
Washer
x 1
H
I
I
F
E
D
G
H
I