Quoizel TFBL9360IB Belle - Manual

Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC 29445
Customer Service
Phone 631.273.2700
Fax
631.231.7102
www.quoizel.com
Tools Required: None.
Bulb Recommended:
Estimated Assembly Time:
Preparation:
(2) Medium Base 100W Maximum, Alternate bulb (2) 23W CFL
10-15 minute
Identify and inspect all parts before beginning installation. Check package content list and diagrams
below to be sure all parts are present. If any parts are missing or damaged, do not attempt to assemble, install, or
operate the fixture. Contact customer service for replacement parts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-TFBL9360IB
For Style TFBL9360IB 6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2014 QuoizelInc. March2014
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
E
A
Base
x 1
Shade
x 1
Care of Tiffany Style Shade
A new tiffany lamp shade has an oil film applied to the shade that protects the tiffany shade from scratches during shipment. If the oil applied is
too heavy you can remove the excess oil film with a paper towel. Gently wipe away the excess oil.
For general cleaning of tiffany shades use a gentle lemon oil-based furniture polish applied to a soft cloth and wipe gently.
If a white powder appears on the soldered joints of the tiffany shade this is a normal oxidation process. Use a small amount of lemon oil or
mineral oil applied directly to oxidized areas and the soldered area will return to like new.
F
Flat
Washer
x 1
Stem
x 1
G
H
Finial
x 1
B
C
D
Socket
Assembly
x 1
Threaded
Rod
x 2
Rod
x 1
STEP 1 Install Rods and Socket
Assembly
-
A. Thread the Socket Assembly (B), the
(C) and the
Base ( ) together as shown. Hand
tighten until snug.
Rod Threaded Rods , the (D)
E
B. Pull the cord from the Base (E) as you
assemble the parts together to remove
the excess cord between parts.
Cord
B
C
D
D
E
STEP 2 Install Stem -
A. Thread Stem (H) into the Hex Coupling
on the top of (B).
Hand tighten until snug.
Socket Assembly
H
Hex Coupling
B
STEP 3 Install Shade -
A. and the
Shade (A) Stem
Stem
Place the Flat Washer (G)
over the (H). Secure
by thread the Finial (F) onto the
(H). Hand tighten until snug.
Figure 1
Figure 2
Figure 3
F
A
G
H