Quoizel VVTH9348AB Vivid Collection Thompson User Manual
Warnings and cautions, Package contents, Replace led lamp
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC 29445
Customer Service
Phone 631.273.2700
Fax
631.231.7102
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-VVTH9348
For Styles VVTH9348BN,VVTH9348AB,
IB
VVTH9348
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,
.
.
.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at
2014 QuoizelInc.
March2014
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
C
A
D
B
E
C
F
Socket
Assembly
x 1
STEP 1
Install Rods and Socket
Assembly
-
A. Thread the Socket Assembly (C) and the
Rods (D/E) to the Base (F) together as
shown. Hand tighten until snug. Note: If the
shade and the base are not lined up after
assembly, unscrew the hex nut on the
bottom of the base with the wrench (B),
adjust the rods until the shade and the base
are lined up. And then secure the rods to
Figure 1
Threaded
Rod
x 1
Rod
x 1
Base
x 1
Tools Required: Flathead screwdriver, Phillips screwdriver.
Bulb Recommended:
Estimated Assembly Time:
Preparation:
LED 7W
15-20 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams
below to be sure all parts are present. If any parts are missing or damaged, do not attempt to assemble, install, or
operate the fixture. Contact customer service for replacement parts.
A
Plug
x 1
B
Wrench
x 1
D
E
F
Adjustment
Button
the base. Hand tighten until snug with
the Wrench (B).
B. Adjust the Support Arm and the Shade
to proper location by adjust the
Ajustment Buttons.
C. Insert the Plug (A) into the cord from
the Base (F) as shown.
Your fixture is now assembled and
ready to use. Enjoy!
Replace LED Lamp
A. Unscrew the lock screws from the shade and remove the diffuser
from the shade.
B. Unscrew the screws on the LED Lamps and remove the LED lamp.
Pull out the connectors from the fixture and seperate the connectors
on the wires.
C. Connect the female connector of the replacement LED lamp to the
male connector from fixture. Attach the LED lamp into the shade
holder and secure with the removed lock screws.
D. Place the diffuser back onto the shade and secure with the removed
screws. Hand tighten until snug.