Quoizel CM8408AC Chalmers - Manual

ILLUSTRATION A
ILLUSTRATION B
CAGE
SOCKET
DOOR
BOLT
BOLT HOLDER
ASSEMBLY / INSTALLATION INSTRUCTIONS
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN! IS-CM8408
Page 1 of 2
Revised 2008 03 22
- -
BACKPLATE
(2)MOUNTING SCREWS
(2)OUTLET BOX SCREWS
(not supplied)
CROSSBAR OUTLET BOX
FIXTURE SUPPLY WIRE
and GROUND WIRE
BRACKET
CAGE
HEX NUT and LOCK WASHER
BACKPLATE
(reverse up to down)
HEX NUT
(small)
WASHER
(small)
TAB
GLASS PANEL
. .
( )
( )
1. Before beginning the installation, carefully unpack and identify all parts referring to
illustration.
2 Turn the electrical power to installation point OFF at circuit breaker
3 Open the Door on the Cage and install the correct bulb(s) referring to the fixture
markings and or labels for maximum wattage Proceed to close the Door by placing the
Bolt onto the Bolt Holder
4 Refer to the Illustration B) Please note that the Backplate can be reversed. Remove the
Hex Nuts(small) and Washers(small) from the back of the Backplate. Loose the Hex Nut and
the Lock Washer. And then push the Backplate as the arrow and reverse the Backplate up to
down. Place the Studs back through the holes on the Backplate and then thread the Hex
Nuts(small) and Washers(small) back onto the Studs. Hand tighten until snug. Proceed to
tighten the Hex Nut and Lock Washer against the Backplate.
5 Place the Crossbar on the Backplate and align the holes in the side of the Backplate with the
threaded holes in the folded edge of Crossbar. Next, mount the Crossbar to the outlet box
with (2)OUTLET BOX SCREWS (not provided).
6. :
Use wire connectors(not supplied) connect the House Ground Wire to the Fixture Ground
Wire; attach the House White Wire to Fixture White (or Ribbed Side) Supply Wire; connect
the House Black (or Red) Wire to the Fixture Black (or Smooth Side) Wire. Wrap each
connection with approved electrical tape.
7. Carefully tuck all wires into the Wall Mounted Outlet Box and position the fixture over the
outlet box. Align the Holes in the side of Backplate with the 2 Mounting Holes on the folded
edge of the Crossbar. Secure them by threading 2 Mounting Screws into the Mounting Holes
on the folded edge. Tighten until snug.
8.Refer to Page 2 for fixture caulking installations.
9. Restore power to the installation point ON. Retain this sheet for future reference.
,
.
/ .
.
.(
.
Make the connections
Note If you find any Tabs do not engage Glass Panels well during assembly please push
the Tabs until they are attaching onto the Glass Panels
: ,
.