Quoizel GT8982IB Georgetown - Manual

FIXTURE
BACKPLATE
FIXTURE
SUPPLY WIRES
AND GROUND
CROSSBAR WITH
GROUND SCREW
1. Before beginning carefully and identify all parts referring to
Figure 1 and Figure 2.
2. (Refer to Figure 1) Turn power to the installation point OFF.
Locate and secure CROSSBAR to the wall mounted OUTLET
BOX with (2) OUTLET BOX SCREWS (not supplied).
3. Make the connections: (Quoizel recommends (2) people
for the next 2 steps. Position the fixture in front of outlet box.
Connect the HOUSE GROUND wire and the FIXTURE
GROUND wire to UNIVERSAL CROSSBAR using GROUND
SCREW (green); using wire connectors (not supplied),
connect the HOUSE WHITE WIRE to the FIXTURE WHITE
WIRE; connect the HOUSE BLACK (or RED) WIRE to the
FIXTURE BLACK WIRE. Make sure there are no exposed
wires.
4. Carefully tuck in all wiring into the OUTLET BOX and position
the FIXTURE over the (2) MOUNTING STUDS. Pass the
studs through the (2) MOUNTING HOLES on the fixture
BACKPLATE. Locate (2) LOCK BALLS and thread onto
ends of studs. To secure FIXTURE to wall, tighten balls until
snug
5. (Refer to Figure 2)Locate the CANDLE COVERS and pass
over the SOCKETS (amount depends on style purchased.
6. Install bulb referring to fixture markings and / or labels for
maximum wattage.
7. Locate SHADE ASSEMBLY and pass the (2) MOUNTING
STUDS at top through the (2) MOUNTING HOLES in
FIXTURE COVER. Thread LOCK BALLS onto studs to
to secure shade. Hand tighten until snug.
8. Refer to enclosed IS-727 for weather proofing instructions.
9. Restore power to the installation point ON. Retain this sheet
for future reference.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!
IS-897
11.01
ASSEMBLY / INSTALLATION
INSTRUCTIONS
FIGURE 1.
FIGURE 2.
6 CORPORATE PARKWAY
GOOSE CREEK, SC. 29445
Note: Generic backplate illustration
FIXTURE
COVER
CANDLE
COVER
MOUNTING
STUD
SHADE
ASSEMBLY
LOCK BALL
LOCK BALL