Quoizel HY8409IB Harmony - Manual

FIXTURE SUPPLY WIRE
and GROUND WIRE
OUTLET BOX
(2) MOUNTING SCREWS
(2) OUTLET BOX SCREWS
(not supplied)
CROSSBAR
( ) 2 MOUNTING BALLS
BACKPLATE
LOCK BALL
FIXTURE HOOD
SOCKET
STUD
FIXTURE FRAME
with SHADE
INSTALLATION INSTRUCTIONS
IS-HY8407
Page 1 of 2
2007-03-03
WASHER
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN!
PAPER CARD
( ) remove duringassembly
PAPER CARD
(
)
remove during
assembly
1. Before beginning installation, carefully unpack and identify all parts
referring to the illustration.
2. Turn power to installation point OFF at the circuit breaker.
3.
4.
5.
Install the correct bulb referring to the fixture markings and/or labels
fox maximum wattage.
Remove the PAPER CARD from the top of the FIXTURE FRAME
and discard it. Lift the FIXTURE FRAME and SHADE upward,
aligning the STUDS through the holes on the FIXTURE HOOD
Secure them together by threading the LOCK BALLS onto the
STUDS and hand tighten both until snug
Place the CROSSBAR on the BACKPLATE and align the holes in
the BACKPLATE with a set of threaded holes in the CROSSBAR.
Install the (2) MOUNTING SCREWS in the aligned threaded holes on
the CROSSBAR. Next, mount the CROSSBAR to the outlet box with
(2)OUTLET BOX SCREWS (not provided).
6.
Use wire connectors(not supplied) and connect the HOUSE
GROUND to the FIXTURE GROUND WIRE attach the HOUSE
WHITE WIRE to the FIXTURE WHITE (or RIBBED SIDE) SUPPLY
WIRE; connect the HOUSE BLACK (or RED) WIRE to the FIXTURE
BLACK (or SMOOTH SIDE) WIRE. Wrap each connection with
approved electrical tape.
7. Carefully tuck all wires into the OUTLET BOX. Align the HOLES in
the BACKPLATE with the 2 MOUNTING SCREWS attached to
the CROSSBAR. Pass the fixture over the 2 MOUNTING
SCREWS and secure against the surface by threading
2 MOUNTING BALLS onto end of the screws. Tighten until snug.
8. Refer to Page 2 for fixture caulking instructions.
9. Restore power to the installation point ON. Retain this sheet for
future reference.
.
.
;
( )
( )
( )
Make the connections: