Monarch Instrument DC1250 - Manual (Page 10)

9
2.0 INSTALLATION AND SETUP
2.1 UNPACKING
2.1.1 Initial Inspection
Exercise care when unpacking the instrument from the shipping carton. The instrument
is packed in a
custom cardboard box to prevent damage during normal transit. If
damage to the shipping carton is evident, ask the carrier’s representative to be present
when the instrument is unpacked.
2.1.2 Unpacking Procedure
To unpack your Recorder, first remove the cardboard retainer and instrument from the
shipping carton.
Check the box for the following contents - The Recorder, two locking
bars, two 6-32 x ½" screws, AC power supply wall unit (unless the unit is the isolated
DC model) and this manual.
2.1.3 Detected Damage
Remove the instrument from the plastic bag and check for damage if any. Also check
that the unit is as ordered.
If damage is detected after unpacking the instrument,
i mmediately report any damage to the shipping agent and re-pack the instrument for
return it to the factory as described in the following section.
2.1.4 Equipment Return
Before returning a damaged or malfunctioning instrument to the factory for repair,
contact the sales organization from which you purchased the instrument. A Return
Merchandise Authorization (RMA) number must be obtained from the factory before
returning an instrument for any reason.
2.1.5 Storage
For prolonged storage before installation, re-pack the Recorder in the shipping
container and store in a cool, dry area. We do not recommend storage of the Recorder
for more than one year. If longer storage time is required, contact the factory for
additional storage information.
2.2 INSTALLATION
The instrument is intended to operate in the following environment:
Indoor Use Only
Installation Category II per IEC 664
Pollution Degree Level II per IEC61010-1
Temperature -10 °C to 50 °C operating per IEC61010-1
Humidity Maximum relative humidity 80% for temperatures up to
31 °C decreasing linearly to 50% relative humidity at 40 °C
Recorder Power 9.0 +0.5V dc @ 5VA (unless indicated otherwise on the unit)
AC Power Requirement (External adapter) 100 - 240 Vac ~ 50/60 Hz
NOTE: The recorder is designed to be panel mounted and as such should be considered
as permanently connected. Disconnection from the supply must be possible via a customer
supplied switch or circuit breaker. This disconnection device must be included in the panel
installation and should be clearly marked, it must be in close proximity to the Recorder and
easily accessible to the operator.
TABLE OF CONTENTS