Monarch Instrument DC1250 User Manual
Page 11
10
NOTE: In order to fully comply with the CE EMC Directive
89/336/EEC,
connections to the
recorder should not exceed 3m (9.8ft) without adding additional filtering.
The Recorder fits in a standard ¼ DIN panel cutout of
92 x 92 mm (3.62 x 3.62 in.)
and
requires 140mm (7.5 inches) panel depth not including space for power and input source
cable.
The thickness of the panel is immaterial, but panels thicker than .125 inch will require
that the locking bars be cut down.
Actual dimensions are shown below in Figure 2.1:
WARNING: Do not use this instrument in any manner inconsistent with these
operating instructions or under any conditions that exceed the environmental
specifications stated.
2.2.1 Panel Mounting
The Recorder should be mounted in a vertical panel to ensure proper operation. Ensure
you have the proper clearances and proceed as follows:
2.2.1.1 Cut a panel opening 92 mm x 92 mm
(3.62 x 3.62 in.).
2.2.1.2 Remove any packaging material from the Recorder. Always handle the unit
carefully to avoid damaging the LCD display or scratching the display
surface.
2.2.1.3 Remove the locking bars from the Recorder enclosure by removing the
captivating screws
2.2.1.4 Insert the Recorder, rear end first, through to front of the panel opening.
2.2.1.5 With the Recorder held firmly in place against the panel, install one of the
locking bar assemblies from the rear, by sliding the locking bar tongue into
the groove on the side of the Recorder enclosure as shown in Figure 2.2.
2.2.1.6 Insert the retaining screw into the rear of the groove. Using a Phillips
screwdriver, tighten the screw until the locking bar is just pressing against
the panel.
2.2.1.7 Install the other locking bar assembly into the groove on the opposite side of
the Recorder enclosure and tighten as before.
5.22
[132.46]
0.30
[7.62]
0.41
[10.41]
0.15
[3.81]
3.78
[96.00]
3.60
[91.44]
4.07
[103.38]
3.78
[96.00]
Figure 2.1 Recorder Dimensions