Wheatheart X13 Reverser Kit - Manual

P ART N UMBER : 30794 R1
R EVISED : 23/11/12
Before starting installation:
• Familiarize yourself with all the required hardware.
• Arrange all parts for easy access.
Refer to the X13 assembly and operating manual for assembly safety and
operating instructions.
PRE-INSTALLATION INSTRUCTIONS
1. Lower the auger to full down position, and disconnect the tractor from the
auger (PTO shaft, hydraulic lines, and hitch).
2. Chock the auger wheels to prevent rolling.
3. Lower the swing hopper fully to the ground.
4. Remove the PTO driveline from the auger.
5. Remove the sprocket shield from the boot.
6. Remove the drive chain from the front of the boot.
REVERSER KIT INSTALLATION
1. Locate hole “ X” and hole “Y” (9 inches from “X”, see Figure 1). Knock the
steel plugs out of these holes using a punch and hammer.
2. Install the reverser base with two 1/2" x 1-1/4" bolts, flat washers and locknuts
(see Figure 2). Do not tighten until step 5.
3. Install the half-link on roller chain and place chain over upper and lower
sprockets, passing it through the reverser base.
4. Join the two ends of the chain together using the half link and the connector
link.
5. Push the reverser base against the chain as tight as possible and tighten the
two 1/2" x 1-1/4" bolts.
Note: It may be necessary to loosen the lower bearing and raise the lower sprocket to
get proper chain wrap on the reverser sprocket.
X13 REVERSER KIT
FOR X1374, X1384, & X1394 AUGER MODELS
INSTALLATION INSTRUCTIONS
Wheatheart
part of the Ag Growth International Inc. Group
P.O. Box 39, Rosenort, Manitoba, Canada R0G 1W0 Ph: (866) 467-7207 Fax: (866) 768-4852
Website: www.wheatheart.com Email: [email protected]
© Ag Growth International Inc. 2013