Wheatheart X13 Reverser Kit - Manual (Page 4)

4
REVERSER OPERATING & SAFETY INSTRUCTIONS
Note: Additional to instructions in operation manual. Read and understand all instruc-
tions before operating auger.
BEFORE OPERATING IN THE NORMAL FORWARD MODE:
1. The stub spline on the PTO driveline must be inserted into the lower spline
coupler and securely locked into place.
2. Make certain the clean-out cover is secured into place on the boot before
operating.
Note: All safety shields must be in place before operating.
TO OPERATE IN THE REVERSE MODE
1. Insert the stub spline on PTO driveline into the upper spline coupler, making
certain it is securely locked into place.
2. Open clean-out cover fully before operating in reverse mode.
3. Operate auger slowly in reverse for a short period of time. DO NOT EXCEED
100 RPM.
4. When boot is nearly full, shut off and lockout power then clean out grain from
boot using a stick. DO NOT USE HANDS. Repeat above procedure as
needed.
Important: The Reverser kit is not designed to assist in unplugging auger. When operating
in the reverse mode, auger must be monitored to prevent boot from overfilling.
Excessive back pressure will cause extensive damage to the auger, which is not
covered by warranty.
CAUTION
• Keep children and all unauthorized personnel clear of work area.
• Shut down and lock out all power before emptying boot.
• Shut down and lock out all power before changing to forward or
reverse modes.
• Ensure that PTO driveline is securely attached before operating.
• Do not exceed reverse operating speed of 100 RPM.
• Do not exceed forward operating speed of 540 RPM.
• Keep body, hair, and clothing away from all moving parts, including
PTO driveline.