Steer-right ehpr valve, Steer-left ehpr valve – Great Plains EHPR Valve Calibration User Manual

Page 4

Advertising
background image

Great Plains Mfg., Inc.

4

EHPR Valve Calibration

401-565M

12/10/2008

Steer-Right EHPR Valve

Refer to Figure 6

10. Activate steer-right calibration by moving the Valve

Select switch

to the RIGHT.

11. Momentarily move the Imin Adjust toggle switch

upwards (increase) direction.

12. Wait a few seconds to detect caster rotation.

You are looking for very slight [slow] movement.

13. If no movement is detected, repeat step 11 until

caster movement is detected. This may require a
considerable number of increases.

14. When movement is detected, and just once, momen-

tarily move the Imin Adjust toggle switch

down-

ward (decrease) direction.

15. Check for caster movement. If caster continues to

move repeat step 14 until movement stops.

16. Press and release the Learn Button

once.

The Learn Acknowledge light

should flash.

17. Move the Valve Select switch

to the center (off)

position.

Steer-Left EHPR Valve

18. Activate steer-left calibration by moving the Valve

Select switch

to the LEFT.

19. Momentarily move the Imin Adjust toggle switch

upwards (increase) direction.

20. Wait a few seconds to detect caster rotation.

You are looking for very slight (slow) movement.

21. If no movement is detected, repeat step 19 until

caster movement is detected. This may require a
considerable number of increases.

22. When movement is detected, and just once, momen-

tarily move the Imin Adjust toggle switch

down-

ward (decrease) direction.

23. Check for caster movement. If caster continues to

move repeat step 22 until movement stops.

24. Press and release the Learn Button

once.

The Learn Acknowledge light

should flash.

25. Move the Valve Select switch

to the center (off)

position.

Figure 6

833-510C HHCT Controls

29197

Valve Select:
Left:

Steer-Left Valve

Center: Off
Right: Steer-Right Valve

Imin Adjust:
Up:

Increase Current to Valve

Center: Off
Down: Decrease Current to Valve

Learn Button:
Press and release to store Imin

Learn Acknowledge:
Light flashes when Imin value stored

Rear Wheel Sensor:
Up:

Enabled

Down: Disabled

Rear Wheel Sensor Light:
If switch

is On, light

flashes when sensor

disk rotates

1

2

3

4

5

6

5

6

1

2

3

4

5

6

1

2

2

3

4

1

1

2

2

3

4

1

Advertising