Great Plains Inline Ripper Gauge Wheel Jack Kit - Manual (Page 3)

5/4/2005 596-158M
Great Plains Mfg., Inc.
3 Installation Instructions
Refer to Figure 3
5. Assemble jack (1) by inserting jack through upper
jack mount plate (2) located on gauge wheel
mount (3). Secure plate (2) to jack (1) with three
7/16-14 x 1 1/4 bolts (4) and nut hex flange locs
(5).
6. Secure jack (1) to gauge wheel jack lower mount
(6) with 7/16-14 x 2 3/4 bolt (7) and nut hex lock
(8).
7. Repeat steps 5 and 6 on opposite side of inline
ripper frame.
NOTE: The jacks should only be used to help raise
and lower the gauge wheels. The cross pin still needs
to be used in order to avoid overloading the jack.
Figure 3 23177