Great Plains Inline Ripper Gauge Wheel Jack Kit - Manual (Page 4)

596-158M 5/4/2005
Great Plains Mfg., Inc.
Inline Ripper Gauge Wheel Jack Kit 4
Mounting the Jack on Gauge Wheels without 12"
Clearance
NOTE: There are two options for mounting jacks to gauge
wheels without 12" clearance. Option 1 moves the gauge
wheels out towards the ends of the frame so they are not
lined up with the tractor tires or hitch. If you choose this op-
tion, move the gauge wheels and follow steps on page 2 list-
ed under Mounting Jack on Gauge Wheels with 12"
Clearance. Option 2 mounts the gauge wheels on the back
side of the front frame tube as shown in Figure 4. If you
choose this option, follow the steps below.
Refer to Figure 4
1. Remove pin securing gauge wheel arm to gauge wheel
mount and remove gauge wheel and arm.
2. Unscrew U-bolts attaching gauge wheel mount to front
side of front frame tube. Keep parts for reuse.
3. Remove gauge wheel mount. Turn mount around so
gauge wheel can be mounted on back side of front
frame tube (3) as shown in Figure 4.
4. Attach gauge mount (1) to back side of front frame tube
(3) with U-bolts (4) removed in step 1.Place gauge
wheel arm (2) on gauge wheel mount (1) and secure
with pin.
Figure 4 23179