Great Plains Yield-Pro Planter Seed Tube - Manual (Page 4)

5/10/2006
Great Plains Mfg., Inc.
Seed Tube Support Update 4
Refer to Figure 8
18. To attach air hoses from manifold box to seed
tubes located on the seed tube bracket, use
the chart on the right.
Refer to Figure 9
19. Leaving air hoses attached to manifold box,
start with outlet 1, shown in the chart, and pull
air hose tightly toward corresponding seed
tube.
20. Approximate amount of air hose needed to
connect manifold box to seed tube. Cut air
hose at approximated distance. Keep all air
hose for reuse.
21. Clamp air hose to corresponding seed tube.
Continue for all air hoses.
Refer to Figure 10
22. Attach remaining air hoses to seed tubes lo-
cated on the seed tube bracket. Secure hoses
to tubes using clamps.
23. Pulling tightly, guide hoses through air hose
support on planter toolbar.
**Viewed as looking at front side of manifold box
sitting in front of box and looking to rear.
**I.E. Outlet 1 feeds left end of planter.
Figure 8
Hose Routing Between Manifold and Seed Tubes
24476
Figure 9
Attach Air Hose to Seed Tubes
24473
Figure 10
Air Hose Support
24475