Great Plains Electronic Acremeter - Manual (Page 14)

Great Plains Mfg., Inc.
14 Electronic Acremeter
194-074M 2014/07/23
Install Sensor
Refer to Figure 14 (this example depicts the 2S-2600)
4.
Select one each new:
168-491D ACREMETER SWITCH MOUNT
221398 SWITCH
and two sets new:
804-036C WASHER FLAT 5/16 SAE PLT
801-067C SCREW RD HD 8-32 X 1 1/2LG PLT
804-043C WASHER LOCK #8
803-064C NUT HEX 8-32
and four new:
804-088C WASHER FLAT #8 SAE PLT
5. Mount the u-shaped face of the switch mount to
the face of the bearing flangette using the existing
flange bolts
, new flat washers and existing
flange nuts .
6. Attach the flat face of the switch mount (part
facing the sensor) using the screws , flat
washers , lock washers and hex nuts .
7. Attach the pickup sensor to the sensor bracket.
Secure the ground wire to one of the mounting
screws. Slide the sensor so it is no more than
1 ⁄
8
inch
from the magnet actuator. Do not allow the sensor to
touch the magnet actuator. Leave screws finger tight
until Step 9.
Note: The individual wire on the sensor is a frame
ground wire that is designed to protect the acre
counter from any static discharge that it may
encounter. It should be attached to the metal on
the drill somewhere.
Figure 14
Install Sensor (2S-2600)
34818
3
28
25
23
20
50
16
25
51
22
13
3
13
28
22
16
23
20
25
13
50 22
51
13
16
25 23 20