Until step 9, Install actuator, Install meter – Great Plains Electronic Acremeter User Manual

Page 15

Advertising
background image

Great Plains Mfg., Inc.

Installation Instructions

15

2014/07/23

194-074M

Install Actuator

Refer to Figure 15 (this example depicts the 2S-2600)
8.

Orient the actuator

so that the snap tabs cannot

entangle debris during rotation (which is top-of-shaft-
forward for the enumerated drill models on page 1).

Note: The acremeter counts rotations of the ground

drive shaft, this is field travelled acres not field
planted acres.

9.

Select one new:

540002-1 7/8 HEX SNAP-ON ACTUATOR

Install the two halves of the magnet actuator
around the shaft and slide the actuator together.
Position the magnet actuator next to the bearing
mount.

Note: Take care when sliding the actuator together to

avoid breaking one of the tabs.

Note: The pulse counter is not rotation direction

sensitive but the position of the sensor to the
spinning magnet actuator is. The sensor should
have the end opposite from the connection
harness towards the shaft and the wide dimension
of the switch housing centered on the plastic
wheel width,

1

8

inch gap is recommended.

Install Meter

Refer to Figure 16
When mounting the acremeter console to the drill frame,
select a location close to the pickup sensor which
allows easy access for reading or adjustments. Pick a
location which allows the console to be mounted in a
vertical position.

Refer to Figure 16 (this example depicts the 2S-2600)
10. Select a ground driven shaft

with easy access.

Select one each new:

823-423C ELECTRONIC ACRE METER

168-492D ACREMETER MOUNT

806-051C U-BOLT 3/8-16 X 6 1/32 X 7

221399 CONSOLE

and two sets new:

804-013C WASHER LOCK SPRING 3/8 PLT

803-014C NUT HEX 3/8-16 PLT

802-826C HHCS #10-24X1 1/4 PLT GR5

804-054C WASHER LOCK #10

803-001C NUT HEX 10-24 PLT

On the front face

of the main toolbar, attach

mount

with U-bolt

using lock washer

springs

and hex nuts

. Attach acremeter

to

mount using screws

, lock washers

and hex

nuts

.

11. Connect the cable from the sensor pickup to the acre

counter console. Through the hole in the mount,
windup and tie out of the way any extra cable.

Figure 15

Attach Actuator (2S-2600)

34820

30

30

30

3

Figure 16

Mount Meter (2S-2600)

34820

18

24

1

17

14

27

2

19

21

26

27

1

27
14
26
29

21
19
17
24
18

2

14

26

21

19

27

17

24

18

Advertising