Great Plains AS PTO Pumps - Manual (Page 2)

2 Application Systems PTO Sprayer Pump 507-095M 4/8/04
Great Plains Mfg., Inc.
Assembly
Figure 2
3P300 Assembly
■
17393
3P300 Assembly
Refer to Figure 2.
1. Mount pump (1) on tractor PTO shaft using shaft coupler (2).
Leave 1/2-inch bolt and nylock nut on tractor end of coupler
loose. Turn pump so coupler is aligned with notch in tractor
PTO shaft. Tighten bolt in coupler.
2. Using 1 1/2-inch hose (3), connect pump inlet (4) to hose
barb on sump valve under sprayer tank. Use worm clamps
to secure hose.
3. Using 1-inch hose (5), connect pump outlet (6) to Whirlfilter.
Use worm clamps to secure hose.
4. Turn PTO shaft by hand to make sure pump and its hard-
ware does not interfere with PTO shields. When satisfied
with pump mounting, torque bolts in shaft coupler to 105
foot-pounds.
5. Use 5/16-inch bolts, flat washers and nuts to secure chain
(7) to tractor drawbar.
6. Hook tarp strap (8) to chain and tractor drawbar so chain
slack is taken up slowly when PTO is engaged.
7. Use cable ties provided to secure hoses. Secure hoses so
they will not be kinked, caught or damaged dur-
ing sprayer operation.