Fasten stops to rows, Adjust wing primary seed hose, Reconfigure wing towers – Great Plains CTA4000HD User Manual
Page 5
Great Plains Mfg., Inc.
Installation Instructions
5
04/02/2009
221-646M
Fasten Stops to Rows
Select all of:
801-025C SCREW HEX 5/16-12X3/4 THD FRM
Insert the screw at the opener frame hole aligned
with the stop plate tab hole, from the side of the
same slot. Drive the self-tapping screw in to a final
torque of:
15 foot-pounds (22 N-m)
Adjust Wing Primary Seed Hose
Primary seed hoses on the wings are re-routed to
improve clearance. These are the larger 2
1
⁄
2
in (6.4cm)
diameter hoses from the airbox to the tower inlets
(bases). Only Towers 1 (left wing end) and Tower 5 (right
wing end) are involved.
Start with Tower 1 (left wing).
Reconfigure Wing Towers
Refer to Figure 8
10. Loosen the hose clamp (not shown) securing the
primary hose (not shown) at the tower inlet
11. If the vertical plate of the mount
is to drill front,
remove the vertical (lower) U-bolts
the mount so the vertical plate is to the back.
12. Loosen the horizontal U-bolts
securing the tower
to the mount.
The tower inlet previously faced forward, perpendic-
ular to the frame tube. Rotate the tower so that the
inlet faces along the frame tube toward drill center.
Adjust the vertical position of the tower so that the
distance from the top of the frame tube to the bot-
tom of the turret plate is 25in (63.5cm). Re-secure
the U-bolts.
13. Repeat step 10 through step 12 for the right wing
and Tower 5. Reset mount plate to back and point
inlet toward drill center.
Figure 7
Securing a Stop
29461
U
D
L
R
B
F
25in (63.5cm)
25in (63.5cm)
ROTA
TE ALONG REAR
ROTA
TE ALONG REAR
FRAME TUBE T
OW
ARD
FRAM
E TUBE
TOW
ARD
DRILL CENTER
DRILL CENTER
4
Figure 8
Reconfigure (Left) Wing Tower 1
16205
29338
2
5
U
D
F
B
L
R
U
D
B
F
R
L
3
2
3