Great Plains 20P 1x12 Press Wheel Arm Extension Kit User Manual
Page 2
199-096M
11/29/2005
Great Plains Mfg., Inc.
20P 1x12 Press Wheel Arm Exten-
sion Kit
2
Refer to Figure 2
2.
Connect spring (4) to appropriate hole
on back of press wheel arm extension
weldment (5).
NOTE: If spring was disconnected form low-
er hole on bottom of opener, attach spring to
lower hole on extension weldment. If spring
was disconncted from upper hole on bottom
of opener, attach spring to upper hole on ex-
tension weldment.
3.
Align top of press wheel arm extension
(1) with press wheel mount (2). Attach
press wheel mount (2) to press wheel
arm extension (1) with 7/16-14 x 5 1/2"
bolt (3) and 7/16" hex lock nut.
Refer to Figure 3
4.
Using 7/16 x 1 1/4" bolt (5) and 7/16"
hex lock nut, attach bottom of press
wheel arm extension weldment (4) to
hole on bottom of opener where spring
was previously attached (6).
5.
Place press wheel arm extension weld-
ment (1) on end of opener (2). Attach
using two 7/16 x 1 1/4" bolts (3) and two
7/16" hex lock nuts.
6.
Tighten all bolts.
Figure 2
Connect Press Wheel Mount and Spring
23073
Figure 3
Attach Press Wheel Arm Extension and Opener
23072
2
1
4
5
3