Great Plains John Deere 455 30' Flat Fold Markers - Manual (Page 11)

10/17/2002 205-046M
9 Operating and Assembly Instructions
Refer to Figure 6
11. Fold the marker to transport position. With the
marker chain (10) in the slot of the support
arm saddle, take up the slack in the marker
chain by threading 3/8” x 2 1/2” long stop bolt
(11) out against the chain bar weldment (1),
lock this stop bolt in position with the two lock
nuts (4).
Refer to Figure 7
12. The marker blade comes factory assembled
as shown. The width of the mark that the
blade makes can be adjusted by changing the
angle of the blade. This is done by loosening
the two 1/2” bolts in the blade adjuster, pivot-
ing the blade to the preferred angle and tight-
ening the bolts.
Refer to Figure 8
13. If desired, the angle of the blade can be re-
versed by turning the blade adjuster upside
down and reversing the blade so the depth
band is on the inside as shown.
Figure 6
Marker Chain
13394
Figure 7
Marker Blade (factory assembled)
Figure 8
Marker Blade (reversed)
11757
11248