Great Plains 3-Point Solid Stand Drills - Manual (Page 4)

113-324M 3/19/03 2 Great Plains Mfg., Inc.
Using this Manual
This manual has been prepared to instruct you in the
safe and efficient operation of your Stand Up Markers.
Read and follow all instructions and safety precautions
carefully.
The parts on your Stand Up Markers have been spe-
cially designed and should only be replaced with genu-
ine Great Plains parts. Therefore, should your Stand
Up Markers require replacement parts go to your Great
Plains Dealer.
The right hand and left hand as used throughout this
manual is determined by facing in the direction the ma-
chine will travel when in use unless otherwise stated.
!
The SAFETY ALERT SYMBOL indicates that there is a
potential hazard to personal safety involved and extra
safety precautions must be taken. When you see this
symbol, be alert and carefully read the message that fol-
lows it. In addition to design and configuration of equip-
ment; hazard control and accident prevention are
dependent upon the awareness, concern, prudence and
proper training of personnel involved in the operation,
transport, maintenance and storage of equipment.
Watch for the following safety notations through-out your
Operators Manual:
!
DANGER!
Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury. This signal
word is limited to the most extreme situations.
!
WARNING!
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
!
CAUTION!
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
Note: Indicates a special point of information which re-
quires your attention.
For your safety and to help in developing a better under-
standing of your equipment we highly recommend that
you read the operator sections of this manual. Reading
these sections not only provides valuable training but
also familiarizes you with helpful information and its lo- cation. The parts sections are for reference only and
don’t require cover to cover reading. After reviewing your
manual store it in a dry, easily accessible location for fu-
ture reference.
Using this Manual
Introduction