Bio-Rad Bio-Plex Software® Upgrades and Conversions - Manual (Page 49)

Start Up and Calibrate
37
Start Up and Calibrate
Each time you use Bio-Plex Manager, the array reader must go through the
start up, warm up, and calibration procedures. The Start up & Calibrate
command allows you to perform these steps with a single command. Click the
Start up & Calibrate button on the Quick Guide or main toolbar, or select the
command from the Instrument menu.
Refer to the following for more information on the individual functions:
• Start Up on page 27
• Optics Warm Up and Shut Down on page 28
• Calibration on page 29
If you prefer, you may perform each function separately. The individual
functions are available on the main toolbar or from the Instrument menu.
BioPlex_6.book Page 37 Friday, September 23, 2011 11:55 AM