Dell Latitude E6400 User Manual

Page 34

Advertising
background image

34

Troubleshooting

D

R I V E

N O T

R E A D Y

The operation requires a hard drive in the bay before it

can continue. Install a hard drive in the hard drive bay. See your Service

Manual at support.dell.com for more information.

E

R R O R

RE AD IN G

PCMCIA

C A R D

The computer cannot identify the

ExpressCard. Reinsert the card or try another card. See your Service Manual

at support.dell.com for more information.

E

X T E N D E D

M E M O R Y

SI Z E

H A S

C H A N G E D

The amount of memory recorded in

nonvolatile memory (NVRAM) does not match the memory installed in the

computer. Restart the computer. If the error appears again, contact Dell (see

"Contacting Dell" on page 65).

T

H E

F I L E

B E I N G

COP I E D

I S

T O O

L A R G E

F O R

T H E

D E S T I NA T I O N

D RI V E

The file

that you are trying to copy is too large to fit on the disk, or the disk is full. Try

copying the file to a different disk or use a larger capacity disk.

A

F I L E NA ME

C A N N O T

C O N T A I N

A N Y

O F

T H E

F O L L O W I N G

CH A RA CT E R S

: \ / : * ? “ <

> | —

Do not use these characters in filenames.

G

A T E

A20

F A I L U R E

A memory module may be loose. Reinstall the memory

modules and, if necessary, replace them. See your Service Manual at

support.dell.com for more information.

G

E N E RA L

F A I L U R E

The operating system is unable to carry out the

command. The message is usually followed by specific information—for

example, Printer out of paper. Take the appropriate action.

H

A R D

-

D I S K

D R I V E

C O N F I G U RA TI O N

E R RO R

The computer cannot identify the

drive type. Shut down the computer, remove the hard drive (see your Service

Manual at support.dell.com), and boot the computer from a CD. Then, shut

down the computer, reinstall the hard drive, and restart the computer. Run

the Hard Disk Drive tests in the Dell Diagnostics (see "Dell Diagnostics" on

page 40).

H

A R D

-

D I S K

D R I V E

C O N T RO L L E R

FAIL URE

0 —

The hard drive does not respond

to commands from the computer. Shut down the computer, remove the hard

drive (see your Service Manual at support.dell.com), and boot the computer

from a CD. Then, shut down the computer, reinstall the hard drive, and

restart the computer. If the problem persists, try another drive. Run the Hard

Disk Drive tests in the Dell Diagnostics (see "Dell Diagnostics" on page 40).

H

A R D

-

D I S K

D R I V E

F A I L U R E

The hard drive does not respond to commands

from the computer. Shut down the computer, remove the hard drive (see your

Service Manual at support.dell.com), and boot the computer from a CD.

Advertising
This manual is related to the following products: