Installing memory – Dell OptiPlex 745 User Manual
Page 85
4.
Remove the memory module. If you are replacing a memory module, see
5.
If you are using a desktop computer, replace the optical drive (see
Optical Drive
).
6.
Replace the computer cover (see
Replacing the Computer Cover
).
Installing Memory
1.
Follow the procedures in
Before You Begin
.
2.
If you are using a desktop computer, remove the optical drive (see
Optical Drive
).
3.
Press out the securing clip at each end of the memory module connector.
4.
Align the notch on the bottom of the module with the crossbar in the connector.
1 memory module
2 securing clip (2)
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
NOTE:
Memory purchased from Dell is covered under your computer warranty.
1 memory connector closest to processor
2 securing clips (2)
3 connector
1 cutouts (2)
2 memory module
3 notch
4 crossbar
NOTICE:
To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the
module.