HONDA 2008 honda civic - Manual (Page 120)

To change the letter, select the
previous segment by pushing the
bottom of the SEEK button. Turn the TUNE knob to change a
letter.
Push the top of the SEEK button
to select the next segment, then
turn the TUNE knob to select a
letter. Repeat this procedure to set
your message.
The system will return to the audio
display about 5 seconds after you
stop selecting a letter.
Push and hold the TUNE knob,
then push the power/volume knob
on the audio control panel. You
will see the first letter blinking.
Make sure the audio system is off.
To select a character:
You can set up to about 16
characters on the display.
You can also customize this welcome
message to your liking with the
audio controls.
Your audio system shows a welcome
message on the display when you
turn the ignition switch to the
ACCESSORY (I) or the ON (II)
position. You can see a message
‘‘WELCOME’’ on the display when
your vehicle was new.
2.
3.
4.
1.
Si model only
Audio System (Models without navigation system)
To Customize a Message
114
TUNE KNOB POWER/VOLUME
KNOB
SEEK BUTTON
０７／０７／０３ ２０：５７：１９ ３１ＳＮＡ６２０ ０１１９